MAINTENANCE
Check that the speed sensor and magnet are in correct alignment and that there are no obstructions on the
magnet. (The magnet can be found on the front roller near the motor belt).
If the running belt moves then displays the E1 error after 10 seconds, replace the speed sensor.
If the running belt does not move, replace the controller.
E3: SELF-CHECKING FAILURE
1. If the running belt does not move, replace the controller.
2. Ensure that all plugs are connected between the motor controller and display.
3. Check that the speed sensor and magnet are in correct alignment and that there are no obstructions on
the magnet. (The magnet can be found on the front roller near the motor belt).
NO POWER
1. Check fuses (They are located on the controller under the motor cover).
2. Check power outlet (Plug something else into the power outlet to ensure that the power outlet is work-
ing correctly).
3. Check Power Cable (You may need to take it to an electrician).
To Next Page
Loading...
