MAINTENANCE
We recommend you use a silicone based spray to lubricate your Life-span Treadmill. This Can be purchased
from your local sports Retailer or a local hardware store.
4.5 BELT ADJUSTMENT
Belt Tension Adjustment-It is very important for joggers and runners in order to provide a smooth, steady
running surface. Adjustment must be made from the right and left rear roller in order to adjust tension with
the Hexagonal Wrench provided in the parts package. The adjustment bolt is located at the end of the rails as
noted in diagram below:
NOTE: ADJUSTMENT IS THROUGH THE SMALL HOLD ON THE END CAPS.
Tighten the rear roller only enough to prevent slippage at the front roller. Turn both the right and left bolt
clockwise reasonably and inspect for proper tension. When an adjustment is made to the belt tension, you
must also make a tracking adjustment to compensate for the change in belt tension.
DO NOT OVERTIGHTEN – Over tightening will cause belt damage and premature bearing failure.
4.6 BELT TRACKING ADJUSTMENT
This treadmill is designed to keep the belt reasonably centred while in use. It is normal for some belts to drift
near one side while the belt is running with no one on it. After a few minutes of use, the belt should have a
tendency to centre itself. If during use, the belt continues to move toward one side, adjustments are necessary.
The procedures are as below:
• First set speed at lowest position.
• Check which side the belt shifts to.
• If the belt shifts to right, tighten the right bolt and loosen the left bolt by using 6 mm Hexagonal Wrench,
until the belt is centred itself;
• If belt shifts to left, tighten the left bolt and loosen the right bolt by using 6 mm Hexagonal Wrench, until
the belt is centred. When adjusting the belt using the 6 mm Hexagonal Wrenches, it is important to
adjust the belt in half turn increments. Over adjusting the belt can cause damage to the mat.
5. TROUBLE SHOOTING
This treadmill is designed in a way that in the event of an electrical fault, the machine will turn off automati-
cally to prevent any injuries to the user and any damage to the machine (i.e. motor). When the treadmill
behaves erratically, simply reset the treadmill by turning the power switch off, waiting for 1 minute then turning
the power button back on. If, after you have reset the treadmill, it is still not running correctly, please run the
self-checking analyse (please refer to Self-Checking) to distinguish what type of error problem the machine is
encountering.
5.1 ALARM SIGNALS
E0: Safety key not in the position
Put the safety key in the position.
E1: No feedback from controller or speed sensor
Check the condition of cables and ensure that all plugs are connected between the motor controller and
display.
To Next Page
Loading...
