Trojan RESPONSE 100 - Frequently Asked Questions

10161 - 14
No. Description Q'ty
11460-01 Main body 1
11460-02 Front Stand Tube (ø60 x 500mm) 1
11460-03 Rear Stand Tube (ø60 x 500mm) 1
11460-04 Bolt (M8 x 70mm) 4
11460-05 Arc Qasher (ø8 x ø20 x T1.5) 8
11460-06 Domed Nut (M8) 4
11460-07 Washer (ø8 x 17 x 1.2) 4
11460-08 Seat 1
11460-09 Seat post (ø38) 1
11460-10 Screw (M5 x 12mm) 2
11460-11 Nut (M8) 3
11460-12
Handlebar Post
(ø50 x T1.5 x 640mm)
1
11460-13 Tension Control Cable Above 1
11460-14 Tension Control Cable Below1
11460-15 Screw (M5 x 14mm) 1
11460-16 Tension Control (ø50) 1
11460-17 Foam grip 2
11460-18 Adjustment Knob 1
11460-19 Computer Wire (700mm) 1
11460-20 Computer (KH-8802) 1
11460-21 Sensor Wire (650mm) 1
11460-22L Pedal (L) 1
11460-22R Pedal (R) 1
11460-23 Sleeve Bellow1
11460-23A End Cap (ø22) 2
11460-24 Screw (M8 x 12mm) 4
11460-25 Handlebar (ø22) 1
11460-26 End Cap of Front Stand Tube (ø60) 2
11460-27 End Cap of Rear Stand Tube (ø60) 2
11460-28L Small Cover (L) 1
11460-28R Small Cover (R) 1
11460-29 Tension Strap (20 x 400 x 670) 1
11460-30 Plastic Sleeve (ø38 )1
11460-31 Tension Strap Clasp 1
No. Description Q'ty
11460-31A Screw (M5 x 6mm) 1
11460-32L Main Cover (L)1
11460-32R Main Cover (R) 1
11460-33 T- knob (M8) 1
11460-A1Crank 1
11460-A2Steel Wheel (40T) 1
11460-A3Washer 1
11460-A4Fixed Cone (R) 1
11460-A5 Ball Retainer2
11460-A6Steel Bowl 2
11460-A7Fixed cone (L)1
11460-A8Washer 1
11460-A9 Lock Nut1
11460-B1 Flywheel (ø200 x 4.5kg) 1
11460-B2 Steel Pulley (16T) 1
11460-B3 Shaft (120 x 32 x 21) 1
11460-B4 Washer (ø35 x 41 x 3) 1
11460-B5 Bearing (6000zz) 1
11460-B6 Spacer (ø16 x 10 x 2.5) 1
11460-B7 Spacer (3/8" x 15 x 5) 3
11460-B8 Washer (ø10 x 19 x 2.5) 1
11460-B9 Lock Nut (3/8")2
11460-B10Spacer (ø16 x 10 x 6) 2
11460-C1 Adjustment Bolt (M6) 2
11460-C2 U-type Bracket Holder 2
11460-C3 Nut (M6) 2
11460-D Chain 1
11460-E Driver 1
9. FREQUENTLY ASKED QUESTIONS
1. The consol is showing the incorrect reading for r.p.m., speed, distance or calories.
• Checkthattheconnectoronthebackoftheconsolispluggedincorrectly.
• Checkthebatteriesintheconsolareinsertedinthecorrectorientationandthattheyareinworkingcondition
• Presstheresetbuttomtotestiftheerrorhascorrecteditself.
2. The Functions are not working properly or display incorrectly.
• Checkthattheconnectoronthebackoftheconsolispluggedincorrectly.
• Presstheresetbuttomtotestiftheerrorhascorrecteditself.
3. There is no pulse reading or the data displayed is unstable.
• Checkthatthereisaproperconnectionbetweenyourhandsandthehandpulse
 connector(thehandpulsesensorswillnotoperatecorrectlyifyourskinisextremelydry.Moistenyourhandsand
tryagain).
• Checkthattheconnectedwireisnotbroken.
• Resetandcarefullyfollowtheinstructionsinthemanual.
Note
• Avoidmovingyourhandswhileexercisingandholdthehandpulsesensorsrmlywhileexercising.Ifyoudomove
yourhandswhileexercising,givethecomputerafewsecondstoresampleanddisplayyourcorrectheartpulse
rate.
4. My LCD is dim
• Checkiftheunitisindirectsunlight,moveifnecessary.Ifdisplaydoesnotimprove,pleasecontact0861876526
4. Maintenance and cleaning.
• Useacleandampsoftragtocleanthesurface.
• Useamilddetergenttocleanthedirtyspots.
• Donotuseasteelbrushoremeryclothtocleanthesurface.
• Immediatelyafterexercisewipeoffanysweatfromthesurfaceoftheequipment.Perspirationcontainssaltwhich
couldruintheequipment.