HOW TO APPLY LUBRICANT
Lift one side of treadbelt.
Pour one half of the lubricant bottle under the center of the treadbelt on the top surface of the treadboard.
Walk on the treadmill at a slow speed for 3 to 5 minutes to evenly distribute lubricant.
NOTE: DO NOT over lubricate treadboard. Any excess lubricant that comes out should be wiped off.
NOTE: ONLY USE HALF THE BOTTLE OF LUBRICANT PER APPLICATION
LUBRICATION SCHEDULE.
1. Check the treadboard lubrication during installation. If it’s necessary, lubricate the treadboard, using the full bottle of
lubricant provided, before using the treadmill for the first time.
2. If the treadmill is used on a regular basis, the running deck should be lubricated once a month.
3. If the treadmill is not used for two months or more, the treadmill must be lubricated before use.
6. MAINTENANCE
Your treadmill should require little maintenance other then
periodically applying lubricant. Lubricating under the treadbelt
will ensure superior performance and extend the treadmill’s
life expectancy.
HOW TO CHECK TREADBELT FOR PROPER
LUBRICATION
Lift one side of the treadbelt and feel the top surface of the
treadboard.
If the surface is slick to the touch, then no further lubrication
is required.
If the surface is dry to the touch, apply one packet of
lubricant or half of the bottle of lubricant.
BELT TRACKING ADJUSTMENT
If during use you notice that the running belt either shifts to
the right or the left of center, first remove “Safety Key” and
unplug equipment from AC power source. Using M6 Allen
wrench provided, turn left rear roller adjustment clockwise
no more the 1/4” of a turn. Remove M6 Allen wrench, insert
“Safety Key” and insert AC power cord into AC outlet. Turn
on your treadmill and observe after running for a few
minutes to see if the problem has been corrected. This may
take several adjustments, so repeat the above procedure.
To Next Page
Loading...
