1563-12
B. MODE FUNCTION KEY
1. Press under START/READY position. MANUAL LED will begin to flash. Press or
to select P1 - P6.
2. MANUAL FUNCTIONS
When MANUAL flashes, press to enter TIME selection. Adjust the TIME using or
When is pressed, the motor will start at a speed of 1.0km/h. Press or to adjust the speed
and the incline of the treadmill
3. P1 - P6 PROGRAM CONTROL FUNCTION (each program has 12 settings)
When MANUAL flashes, you can press or to select. Press to confirm.
After selecting the desired program, the corresponding light will keep on flashing.
The CALORIES window will display the exercise level (L1-L3). You can press or to change to the
desired level, then press to confirm.
After the level selected, the TIME window will begin to flash, at this time you can press or
to change the TIME. After the desired TIME is set, press to confirm.
Preset time value: 25min
Range of time: 5 - 99min
Press and the treamill will run according to the preset value of the program. The speed and angle of the
program’ 12 segments will change automatically according to the preset values. The first segment will last 2 min. with
each following segment lasting 1min. SPEED will change automatically.
During exercise you can press or to directly change the SPEED..
During the setting of P1 - P6, if is pressed, the treadmill will START with all unset values preset.
Press or to change the preset SPEED value of PROGRAM, but the value will reset in the next
segment, to the original value of the PROGRAM.
P1 as a set PROGRAM.
This PROGRAM is set to 3500 meters. After you cover 3500m, the PROGRAM is finished, and the treadmill wil
stop. This program simulates walking on a golf course.
Each PROGRAM has a 1min warm up.
COMPUTER FUNCTIONS
To Next Page
Loading...
