Need help?Do you have a question about the TRONXY P802M and is the answer not in the manual?
General| Brand | TRONXY |
|---|---|
| Model | P802M |
| Category | 3D Printers |
| Language | English |
Assembling the extruder by mounting bearings, motor & hotend module, fan, and cooler fan.
Assembling the Z-axis motor with side and top supports, and attaching the coupling.
Installing the PCBA control board onto the side plate using screws, pillars, and nuts.
Assembling the bed frame by attaching three bearings to the frame using twelve M4*15mm screws.
Installing M8*380mm sliding rods through the bed frame and attaching the timing belt.
Illustrates wiring connections for motors, sensors, and power to the control board.
Details AC power cable connection and voltage selection for the power supply.
To Next Page
