Need help?Do you have a question about the TRONXY X5SA and is the answer not in the manual?
Provides an overview of how various components connect to the main board.
Guides users through navigating the main menu, system, tool, and print options.
Instructions for preheating the nozzle and bed, and loading/unloading filament.
Explains both automatic and manual bed leveling methods.
Guides on adjusting the Z-axis offset for precise first layer printing.
Explains how to stop, save, and resume prints from a breakpoint.
General| Print Technology | Fused Deposition Modeling (FDM) |
|---|---|
| Build Volume | 330 x 330 x 400 mm |
| Layer Resolution | 0.1 - 0.4 mm |
| Nozzle Diameter | 0.4 mm |
| Filament Diameter | 1.75 mm |
| Connectivity | USB, SD card |
| Frame Material | Aluminum |
| Bed Leveling | Manual |
| Bed Temperature | Up to 100°C |
| Nozzle Temperature | Up to 275°C |
| Print Speed | 20-100 mm/s |
| Software | Cura, Repetier-Host |
| Power Supply | 24V |
| Supported Filament Types | PLA, ABS, PETG, TPU |
| Print Bed | Heated |
| Extruder Type | Single |
To Next Page
