Need help?Do you have a question about the TRONXY XY-2 PRO and is the answer not in the manual?
General| Build Volume | 255 x 255 x 260 mm |
|---|---|
| Layer Resolution | 0.1-0.4 mm |
| Print Speed | 20-100 mm/s |
| Filament Diameter | 1.75 mm |
| Nozzle Diameter | 0.4 mm |
| Connectivity | USB, SD card |
| Bed Leveling | Automatic |
| Frame Material | Aluminum |
| Bed Temperature | Up to 100°C |
| Nozzle Temperature | Up to 260°C |
| Printing Technology | FDM |
| Extruder Type | Single |
| Heated Bed | Yes |
| Supported Filaments | PLA, ABS, TPU, Wood |
| Power Supply | 24V 360W |
| Machine Weight | 8.5 kg |
Details print size, accuracy, principle, nozzle, speed, and position accuracy.
Illustrates connections for the switch board and Z motor lines.
Step-by-step instructions for correctly installing the switch line connector.
Guides for manual and automatic leveling of the print bed.
Troubleshooting for power-on failures and SD card read errors.
Diagnosing filament feeding, extrusion, motor noise, and step issues.
To Next Page
