Trotec Speedy 360 Guide

- 3 -
Trotec Laser Cut
The cut data is transmitted from FineCut to Trotec JobControl and then laser cutting is performed by the Tro-
tec Speedy Laser Engravers (100/300/360/400).
This document covers the basic procedure for using FineCut 8 and RasterLink to print with a printer manufac-
tured by MIMAKI ENGINEERING CO., LTD. (hereinafter referred to as a "Mimaki printer") and carry out laser
cutting with the Trotec Speedy Laser Engraver. The following example shows the case when the FineCut and
Trotec software is installed on the LaserCut PC and the RasterLink software is installed on the RasterLink PC.
• Trotec Laser Cut procedure (when laser cutting is performed automatically according to out-
put from FineCut).
*1. FineCut is compatible with Trotec Speedy Laser Engravers 100/300/360/400 laser engraving ma-
chines.
Engraver(PrinterDriver)
100/300/360/400
1. Transmission of print data (P. 20 )
Hot folder
Data creation, etc.
Laser Cutting
Printing
2. Output of print data (P. 20)
3. Transmission of cut data
Auto
*1
Auto
When UniDrive
Quick Print is ON
Auto
Conversion
folder
Image quality
adjustment,
color adjustment,
etc.
File conversion
Setting output
conditions
Setting cutting conditions
Laser engraving machine control, etc.

Trotec Speedy 360 Specifications

General

Max. Speed	3.55 m/s
Laser Type	CO2 Laser
Software	JobControl
Resolution	1, 000 dpi
Positioning Accuracy	0.1 mm
Repeatability	± 0.01 mm
Power Supply	110 - 240 V, 50/60 Hz
Weight	220 kg
Laser Power	10 - 120 watts