Trotec TGP 1005 E - Maintenance

EN 11
garden pump TGP 1005 E
• Check whether the suction height or delivery head exceeds
the max. specifications indicated in the technical data, and
reduce it if necessary.
• Check whether the hose line is kinked or blocked. Remove
kinks and/ or blockages.
• Check whether the prefilter is contaminated at the intake
opening. Remove any dirt.
• Check whether the suction line is clogged at the intake
opening. Remove any dirt.
• Inspect both the pressure and suction line for leaks, and
replace them if necessary.
Note
Wait for at least 3 minutes after maintenance and
repair work. Only then switch the device back on.
Your device still does not operate correctly after these
checks?
Please contact the customer service. If necessary, bring the
device to an authorized specialist electrical company or to
Trotec for repair.
Maintenance
Activities required before starting maintenance
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
• Switch the device off.
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
Notes on maintenance
Inside the device, there are no parts that need to be maintained
or lubricated by the user.
Note
If there is a danger of frost, drain all water from the
device via the water drain nozzle(5) to prevent the
device from being damaged. Before restart, the device
must be filled with water again.
Safety signs and labels on the device
Check the safety signs and labels attached to the device at
regular intervals. Replace illegible safety signs!
Cleaning
• Clean the device with a soft, damp and lint-free cloth.
Protect electrical components from moisture. Do not use
any aggressive cleaning agents such as cleaning sprays,
solvents, alcohol-based or abrasive cleaners to dampen
the cloth.
• Rinse the inside of the device with clear, lukewarm water.
Cleaning the prefilter
The prefilter must be cleaned as soon as it is contaminated.
This is brought to light e.g. by a reduced pump capacity (see
chapter Errors and faults).
1. Loosen the screw plug at the water filler neck by using the
wrench(3) and unscrew it.
2. Remove the prefilter(11).
11
3
3. Tap the prefilter against a flat surface.
4. Clean the prefilter with soapsuds, then rinse with clear
water.
5. Allow the prefilter to dry.
6. Reinsert the prefilter and reattach the screw plug. Ensure a
tight fit of the screw plug and tighten it using the wrench.