Trotec TGP 1005 E - Operation

EN 9
garden pump TGP 1005 E
2. Fill the device with the pumping medium all the way to the
edge via the water filler neck(3). The connected suction
line should also be completely filled with the pumping
medium.
3. Screw the screw plug back onto the water filler neck(3).
Ensure a tight fit of the screw plug and tighten it using the
wrench.
Bleeding the pressure line
Please observe the following information before bleeding or
switching the device on:
• Make sure that the mains connection corresponds to the
specifications provided in the technical data.
• Check the mains socket for its proper condition and
sufficient fusing.
• Make it impossible for moisture to reach mains plug or
socket. There is a risk of electric shock!
• Check whether the pressure and suction line were properly
attached.
1. Open all consumers connected to the pressure line to
bleed the pressure line.
2. Switch on the device as described in the Operation chapter
and wait until the device has sucked in water or until water
flows out of the consumers.
Operation
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
Switching the device on
1. Plug the mains plug into a sufficiently fused mains socket.
2. Switch the device on by setting the on/off switch(1) to
positionI.
3. After switch-on, regularly check whether the device
operates correctly. Turn off the power supply if after start-
up of the motor the pump shows an unusual operational
behaviour (such as strong vibrations at the pump or
pressure line, a fluctuating flow rate or similar). If you
leave the device unattended for a longer period of time,
interrupt the device's power supply.
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
Warning
The device is pressurized. Before opening the screw
plug at the water drain nozzle(5) or before
disassembling the pressure line, the pressure must be
released from the pressure line via the lowest-level
consumer.
1. Switch the device off by setting the on/off switch(1) to
position0.
2. Hold onto the mains plug while pulling the power cable out
of the mains socket.
3. Open the lowest-level consumer to reduce the pressure in
the pressure line.