Trotec TGP 1005 E - Information about the Device; Transport and Storage

6 EN
garden pump TGP 1005 E
Information about the device
Device description
The device is used to pump service water for the home and
garden.
The device is able to suck in clear water from wells, rain water
barrels or cisterns from a depth of up to 7m, and to pump it up
to a height of 42m.
The water temperature must not exceed 35°C.
For a permanent installation, the device is fitted with feet with
drill holes allowing it to be bolted to the ground. The device can
be filled with water via the water filler neck. The water can be
drained via the water drain nozzle.
Device depiction
1
2
3
4
5
6
7
No. Designation
1 On/off switch with protective cover
2 Connection for pressure line with 1"internal thread
3 Water filler neck/prefilter
4 Connection for suction line with 1"internal thread
5 Water drain nozzle with screw plug
6 Transport handle
7 Foot (with drill hole)
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
To make the device easier to transport, it is fitted with a carry
handle.
Before transporting the device, observe the following:
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
• Only carry the device by the transport handle.
• Do not carry the device by holding it at the power supply
cable or hose.
Storage
When the device is not being used, observe the following
storage conditions:
• dry and protected from frost and heat
• in an upright position where it is protected from dust and
direct sunlight
• with a cover to protect it from invasive dust, if necessary
• Check whether there is residual water left in the device,
and drain any residual water via the water drain nozzle(5)
to prevent rust formation.
• Put the protective caps on the pressure and suction
connection to protect the inside of the device against dust
and dirt.
If you do not use the device for an extended period of time, it
must be cleaned thoroughly after its last application and before
recommissioning. Deposits and residues could lead to start-up
difficulties.
For restart, please proceed according to the Start-up chapter.