SETTING THE COUNT TIME
The count time defines how long the gauge reads. Longer count
times produce better measurement precision. Troxler recommends a
count time of one minute for most sample measurements.
To change the count time, press 〈TIME〉 to display:
Time: x min
(↑ ↓ or ENTER)
Use the up and down arrows to scroll through the available count
times. When the desired count time is displayed, press
〈START/ENTER〉.
SETTING THE DEPTH
To change the depth of measurement, press 〈DEPTH〉.
Depth: x in.
(↑ ↓ to change)
Use the up and down arrows to scroll through the available
measurement depths. When the desired depth is displayed, press
〈ON/YES〉 to select the displayed depth and return to the Ready
mode.
SELECTING THE MODE (MARSHALL/PROCTOR)
The gauge may be used on construction materials (soils, asphalt,
concrete, and so on). To select the Soil mode, enter or activate a
Proctor value. To select the Asphalt mode, enter or activate a
Marshall value. Only one Marshall and one Proctor can be stored in
the gauge at one time.
2–6
To Next Page
Loading...
Need help?
General