CHAPTER 2: ASSEMBLY INSTRUCTIONS
Truefitness.com / 800.426.6570 / 636.272.7100 14
TREADMILL ASSEMBLY STEPS (continued):
Step 3-2B Frame Cable Connections:
*TOUCHSCREEN CONSOLES & 15” TFT CONSOLES ONLY
a) Place Auxiliary Power Supply
(included in console box), in motor
area floor location shown.
b) Connect TCPS Power Supply AC
connector (large connector w/ 3 pins)
into Auxiliary Power Supply as shown
in picture. Make sure connector is
fully inserted.
c) Secure Auxiliary Power Supply to
floor using the supplied wire ties.
NOTE: The Auxiliary Power Supply
will be pre-installed in 220v units.
d) Separate the AUXPS cables that are
attached to the CNTRL cable and cut
the wire tie holding the female end of
the AUXPS cable to the CNTRL cable
as shown.
) Connect the female end of the
AUXPS Cable coming from Pedestal
to AUXPS Power Supply Cable.
f) Connect the CNTRL cable to the
smart board as shown
NOTE: The male end of the AUXPS
cable wire tied to the CNTRL cable is
not used for this installation.
Make CNTRL
Connection Here
TCPS Power Supply
Connector
To Next Page
Loading...
