CHAPTER 2: ASSEMBLY INSTRUCTIONS
Truefitness.com / 800.426.6570 / 636.272.7100 11
TREADMILL ASSEMBLY STEPS:
STEP 1: Remove Motor Cover:
a) Remove two screws (l) and two
Motor Decoration Covers from
Frame.
b) Remove seven screws (m) and
Motor Cover from Frame.
c) Set hardware to the side for use in
step 4.
STEP 2: Pedestal Installation:
a) Check that Hex Head Bolts in Fig
2-1 are backed out enough to clear
Pedestals when installed.
b) Install Pedestal – R (D) into
pedestal support on Frame (B) while
pulling four cables out of pedestal
support as shown in Fig. 2-1.
NOTE: Be careful not to pinch cables.
c) Install Pedestal – L (C) into
pedestal support on Frame.
d) Using 5mm Hex Key, install but do
not tighten eight Bolts-M8 x 75mm
(b) and Washers-M8 (d) as shown .
Required Hardware:
8 M8 x 75mm Bolts (b)
8 Internal Tooth M8 Washers (d)
To Next Page
Loading...
