CHAPTER 2: ASSEMBLY INSTRUCTIONS
Truefitness.com / 800.426.6570 / 636.272.7100 17
TREADMILL ASSEMBLY STEPS (continued):
STEP 8: Bottom Shoulder Covers:
a) Using a Phillips screwdriver, install
Shoulder Cover Bottom pieces Left
(G) and Right (H) with five Screws
M4 x 10mm (c) on each side as
shown.
CAUTION: Make sure cabling is
NOT pinched during installation.
Required Hardware:
10 M4 x 10mm screws (c)
a) Attach console to mast using the 4
M5x12 screws that come with the
console.
Required Hardware:
Included with console.
STEP 10: Ground Wire Connection:
a) Attach ground wire coming from
the back of the console to the ground
screw.
ground wire here
To Next Page
Loading...
