True CS400 - Product Overview

CHAPTER 2: ASSEMBLY INSTRUCTIONS
Truefitness.com / 800.426.6570 / 636.272.7100 21
TREADMILL ASSEMBLY STEPS (continued):
STEP 12: Rear Console Cover:
a) Attach the rear console cover (L)
with 3 Screws M4 x 0.7 x 10mm (c) as
shown.
Required Hardware:
3 M4 x 10mm screws (c)
STEP 13: Power Cord Installation:
a) Insert Power Cord into Power Inlet
shown to the right.
NOTE: 230V Front Electrical Panel
will appear different from the figure
to the right. The circuit breaker is not
visible and is within Power Switch.
POWER SWITCH: | = ON, 0 = OFF
CIRCUIT BREAKER: In the event
the current drawn by the treadmill
exceeds a specified threshold value,
the Circuit Breaker will pop out, and
open the circuit. If this should occur,
please wait 10 minutes and then reset
the Circuit Breaker by pressing the
button in on Circuit Breaker. If it does
not reset, or the Circuit Breaker pops
out again, please contact TRUE
Fitness Service department at
1-800-883-8783.
Power Inlet
(120V Shown)
Power Switch
Circuit Breaker
Coax Cable
Port
Network Port
Circuit Breaker Positions
CLOSED
OPEN