23
Problem Potential cause Resolution
Water escaping
at pressure relief
valve.
Water pressure in water system too
high.
Adjust the water pump pressure to a
maximum of 65 psi (4.5 bar).
If the water system is connected to a cen-
tral water supply higher than 65 psi (4.5bar)
(rural or urban connection), a pressure
reducer must be used.
Install a pressure reducer (e.g. Truma
pressure reducer) at the fresh water
supply.
Water cannot expand in the water
system.
Contact the vehicle manufacturer about
retrofitting a pressure compensation ele-
ment.
Lime or dirt under the pressure
relief valve seat.
Allow the appliance to cool and then
slowly raise the test lever (Fig. 3 – 4a)
to flush the water system and attempt
to force dirt or foreign matter out of the
pressure relief valve seat.
Replace pressure relief valve. This must
be performed by a Truma certified service
technician.
Water escaping
at water inlet filter
Lime or dirt under the O-ring seats. Clean the O-rings and their correspond-
ing sealing surfaces with clean water.
AquaGo comfort / AquaGo comfort plus
The yellow status
LED 3 is off al-
though an oper-
ating mode was
selected.
Power switch is OFF. Switch ON the appliance at the POWER
switch.
Power supply to the appliance is
switched off.
Switch on the power supply to the appli-
ance.
Power supply was interrupted. Reset by switching OFF at the con-
trol panel, waiting 2 seconds and then
switching on again.
If none of the measures in the troubleshooting chart proves successful, please contact your dealer,
the Truma Service Center at 1-855-558-7862 or one of our authorized service partners.
To Next Page
Loading...
Need help?
General
