14
Symbols used
The device must only be installed and repaired by an
expert.
Symbol indicates a possible hazard.
Note containing information and tips.
Safety instructions
Repairs may only be carried out by an
expert!
To avoid transportation damage, the device
may only be dispatched if the Truma Service
Centre in Germany or the respective au-
thorised service partner has been consulted
beforehand.
The power supply must be disconnected
from the mains (all poles) before opening the
housing.
The 230 V, T 6.3 A H-type (slow, IEC 127)
device fuse can be found on the electronic
control unit in the device, and must always be
replaced with an identical fuse.
The device fuses and connection cables must
only be replaced by experts.
Guarantee claims, warranty claims and ac-
ceptance of liability will be ruled out in the
event of the following:
– Modifications to the device (including
accessories)
– Failure to use original Truma parts as re-
placement parts and accessories
– Failure to follow the installation and operat-
ing instructions
This may also invalidate the device operating
permit, which in many countries also denotes
cancellation of the vehicle operating permit.
The refrigerant circuit contains R 407C re-
frigerant and must only be opened in the
factory.
Saphir comfort RC air conditioning system
Table of contents
Symbols used ...................................................................... 14
Safety instructions ........................................................... 14
Notes on using air conditioning systems ..................... 15
Operating instructions
Remote control .................................................................... 16
IR receiver and manual on / off ........................................... 17
IR receiver / function indicator ............................................ 17
Red LED illuminated ............................................................ 17
Start-up ................................................................................ 17
Switching on ....................................................................... 17
Temperature ........................................................................ 17
Mode ................................................................................... 17
Fan ....................................................................................... 17
Sleep function ..................................................................... 17
Switching off ....................................................................... 17
Time ..................................................................................... 17
Timer ON / OFF .................................................................... 18
Reset .................................................................................... 18
Resend ................................................................................. 18
Setup ................................................................................... 18
Maintenance ..................................................................... 18
Troubleshooting ................................................................... 18
IR remote control battery change ....................................... 19
Disposal ............................................................................. 19
Accessories ....................................................................... 19
Technical data ................................................................... 20
Installation dimensions ........................................................ 20
Truma Manufacturer’s Warranty ................................... 21
Scope of delivery ................................................................. 21
Intended use ........................................................................ 21
Regulations .......................................................................... 21
Selecting a location ......................................................... 21
Installation instructions
Installing the air conditioning system .......................... 22
Cold air distribution and circulated air return ............. 23
Air distribution ..................................................................... 23
Circulated air return ............................................................. 23
Installing the IR receiver ................................................. 23
230 V electrical connection and
connection of IR receiver ................................................ 23
Function test /
IR remote control mounting ................................................ 24