Trynex Sweepex SWB-400

Questions and Answers

J
Justin BurtonAug 19, 2025
Why Trynex Sweepex SWB-400 Lawn Sweeper motor will not start?
- L
  Lori LeeSep 12, 2025
  The Trynex Lawn Sweeper motor might not start due to several reasons: the fuel tank could be empty (fill the fuel tank); the throttle lever might not be set to choke when the motor is cold (set the throttle lever to choke); the spark plug leads might not be connected (connect the spark plug leads); the fuel line might be blocked (send the fuel line to a dealer for cleaning); the motor might be receiving the wrong air due to a loose carburetor (tighten the fixing screws); or the fuel valve might be closed on a Honda motor (open the fuel valve).
J
Jamie TurnerAug 21, 2025
What to do if Trynex Sweepex SWB-400 Lawn Sweeper motor is overheating?
- K
  katiedavisAug 21, 2025
  If the Trynex Lawn Sweeper motor is overheating, it could be due to several reasons: the oil level might be too low (refill motor oil); the air cooling system might be restricted (send to dealer/adjust air cooler grille and cooling ribs); the air filter might be dirty (clean air filter); or the carburetor might not be correctly adjusted (adjust Carburetor/Send to dealer).
S
Sarah Harrison DDSAug 23, 2025
What to do if Trynex Lawn Sweeper motor running badly, misfires?
- F
  Frank DominguezAug 25, 2025
  If the Trynex Lawn Sweeper motor is running badly and misfiring, it could be due to the motor running with the choke activated (move throttle lever out of choke position); spark plug leads loose (allow motor to cool and connect spark plug leads firmly); air filter soiled (clean air filter); air bleed hole in fuel tank filler cap blocked (replace fuel tank filler cap); fuel line blocked (clean fuel lines); replace fuel lines; run fuel system cleaner through tank of gas; carburetor not correctly adjusted (adjust Carburetor/Send to dealer); motor overheating (see fault “Motor Overheating”).
W
William SmithAug 26, 2025
What to do if Trynex Lawn Sweeper motor will not start and smells of gasoline?
- R
  ronniesantosAug 26, 2025
  If the Trynex Lawn Sweeper motor won't start and there's a gasoline smell, it could be that the motor is receiving too much fuel (set throttle lever to full speed, not to choke) or the air filter is dirty (clean air filter).
R
Rachel OrtizAug 28, 2025
Why Trynex Sweepex SWB-400 motor has lost power?
- M
  millerchristopherAug 28, 2025
  The Trynex Lawn Sweeper motor may have lost power because the air filter is soiled (clean the air filter) or the compression is too low (send to dealer for adjustment).
M
Miguel PeckAug 30, 2025
What causes Trynex Sweepex SWB-400 motor to misfire at high speed?
- J
  Joshua AllenAug 30, 2025
  The Trynex Lawn Sweeper motor may misfire at high speed if the spark plug gap is not correct (adjust spark plug gap/send to dealer) or the carburetor is not correctly adjusted (adjust Carburetor/Send to dealer).
K
Katie SchwartzSep 2, 2025
What to do if Trynex Sweepex SWB-400 machine leaves unbrushed central strip?
- T
  Timothy SweeneySep 2, 2025
  If the Trynex Lawn Sweeper leaves an unbrushed central strip, it could be due to the discharge direction being forward with worn brushes (turn the discharge direction to the side) or the brushes being worn (replace brushes).
M
Manuel RodriguezSep 4, 2025
Why Trynex Sweepex SWB-400 motor often stops during turnover?
- D
  David JimenezSep 4, 2025
  The Trynex Lawn Sweeper motor might often stop during turnover if the throttle lever is not set to choke when the motor is cold (set throttle lever to choke), the spark plug gap is not correct (send carburetor to dealer for adjustment), or the air filter is dirty (clean air filter).
D
donald31Sep 6, 2025
Why Trynex Lawn Sweeper brushes do not turn, or stop moving under load?
- M
  Michelle MillerSep 7, 2025
  If the Trynex Lawn Sweeper brushes do not turn or stop moving under load, it could be because the switch lever is not completely pressed down (press switch lever completely down), the control cable is not correctly adjusted (re-adjust brush control cable), or the toothed belts are defective (send to dealer).
A
alvaradokatherineSep 8, 2025
Why Trynex Lawn Sweeper machine will not move forward?
- M
  Michael NewtonSep 9, 2025
  The Trynex Lawn Sweeper machine might not move forward if the movement control cable is not correctly adjusted (re-adjust control cable) or the tension on the toothed belt between the motor and gearbox is too low (send to dealer).