Trynex Sweepex SWB-400 - Maintenance Schedule

22 © TrynEx International 2013 (REV A) F51231A
Maintenance Instructions
Maintenance Plan / Cleaning
before every
use
after the following operating hours
after 3 month
min.
at least
anually
after every
cleaning
5 10 25 50 100
Check screws and nuts
C
Check motor oil level, rell if necessary
C
First motor oil change
S
All further motor oil changes
S S
Check air lter
C
Clean air lter element, earlier if necessary
M M
Replace air lter element, earlier if necessary
M
Replace fuel hoses
S (2 Years)
Clean cool air screen
M
Clean bafe plate, cooling ribs, earlier if neces-
sary
S
Clean spark plugs, adjust gap
S
Replace spark plugs
S
Clean exhaust
M
Lubricate all moving parts
M M
Check hand lever play setting
C
Check brush wear, earlier if necessary
C
Stretch chain drive
C S
KEY
S Maintenance by Specialist
C Check by Operator
M Maintenance by Operator
IMPORTANT
If you are not intending to use the machine for a long time, it should be properly stored. Please contact your local dealer for
suitable storage practices in your geographic location.
CLEANING
To keep your SWB-400 in good condition, you should clean it regularly.
Remove loose dirt or dust with a car wash brush. Wash plastic surfaces with water and soap. Use normal car cleaning soap. Rinse off all
cleaners thoroughly with clean water.
To give plastic parts a gloss nish, use a plastics care product.
Observe the instructions on the cleaning solution package.
You can use glycerine as a corrosion protection for heavily soiled parts.
Do not use pressure washers, the high pressure may force water into bearings, seals and the motor, causing damage.