18 © TrynEx International 2013 (REV A) F51231A
Operating Instructions
Plow Blade (Optional Accessory)
An angled setting must be used when plowing snow.
The plow is not necessary when clearing small amounts of snow – 1 inch or less (2.5 cm).
For snow over 1 inch (2.5 cm), use the plow blade.
The SWB-400 with the SSB-400 Plow can clear a maximum of 5-1/2 inches (14 cm) snow
in one pass.
If snow is heavy the capacity will be less.
See “Freewheel” to adjust freewheel correctly for plowing snow.
SWB-400 with optional Snow Plow (SSB-400)
The Snow Brush Kit (SRS-400) is
recommended when clearing snow.
To install the Plow Blade: lift the Plow and
hold it at an angle; slide it over the Receiver
Bars and lower it into position.
Plow hanging on Receiver Bar. Lower Support.
OPERATING
ATTACHING SNOW PLOW TO SWEEPER...
To Next Page
Loading...