7© TrynEx International 2013 (REV A) F51231A
Operating Instructions
General Safety / Operating in Winter
GENERAL SAFETY
Do not operate the machine in an unsafe manner! Make yourself familiar with the surroundings before start-
ing work in a new location. The working surroundings include any obstacles in the work area or on roads,
the ground load-bearing capacity and any necessary workplace safety precautions in live trafc.
Take precautions to ensure that the machine is only operated in a safe and functional condition! Only oper-
ate the machine if all protective and safety devices are present and working!
Check the machine for externally visible damage and faults before operation! If malfunctions occur stop
the machine and secure it immediately! Repair malfunctions immediately! Only start the machine from the
operator’s position! Ensure that no one can be endangered by starting the machine before switching it on or
operating it!
Check that braking, steering, and brushing are fully functional before operation!
Before operating the machine, always check that accessories are tted correctly! Always observe applicable
trafc regulations before operating on public roads, paths or parks, and ensure that the machine is in a
condition suitable for use in trafc
Always ensure that suitable lighting is available before working in poor light or darkness! Always keep a suf-
cient distance between the machine and drop-offs, holes or slopes!
Do not permit any method of working which will affect the stability of the machine!
Never traverse across slopes; always travel up and down, not across.
Adjust the speed to suit the conditions on inclines! Change gear before the incline, not on it! Always secure
the machine against rolling away and unauthorized operation before leaving it unattended!
OPERATING IN WINTER
Check regularly that the air lter is dry. If the air lter has become wet, let it dry overnight. There is a pos-
sibility of the engine not starting due to a clogged air lter.
Spray the throttle cable with silicone spray at both ends, and the throttle linkage before operating to prevent
the cable or throttle mechanism from freezing up.
Before putting the machine away, sweep it clear of snow.
Avoid freezing the machine. Store the machine in a frost-free room.
Silicone Spray attracts dust and binds it to the machine. It is only a suitable lubricant in wintry and snowy
conditions.
Do not spray Silicone Spray on hot engine. It could cause a re. Follow the instructions on the spray can.
Remove Foam Pre-Filter.
Use SAE 5W-30 Motor Oil.
To Next Page
Loading...