Trynex Sweepex SWB-400 - SWB-400 Maintenance Instructions; Oil and Gasoline Management

19© TrynEx International 2013 (REV A) F51231A
Capacities:
Oil 0.58 qt. (0.55 L)
Gasoline 0.95 qt (0.9 L)
Use 86 octane or higher unleaded gasoline.
1. Remove oil cap; wipe dipstick clean.
2. Replace dipstick in the oil ller neck; do not screw down.
3. Remove dipstick; check oil level. The oil should be up to the upper
marking.
4. If oil level is low, ll up to the upper marking on the dipstick with
the recommended oil (see Honda Owner’s Manual).
5. See marking on the dipstick for ll level.
Maintenance Instructions
Tire Pressure / Oil and Gas
IMPORTANT
If the tire pressure is too low, the inner-tube will rub against the wheel and be damaged.
Over-Ination can cause the tire to burst.
Check the tire pressure for both the support and drive wheels regularly.
Unscrew the valve cap and use a tire ination device to check or inate the tire as necessary. Always replace the valve cap when you have
nished inating.
DRIVE WHEELS
22 psi (1.5 bar).
SUPPORT WHEEL
30 psi (2 bar).
On Rough Surfaces:
22 psi (1.5 bar)
OIL AND GAS
FILL LEVEL
OIL
GAS