TSC MB240 Series User Manual

- 46 -
6.5.2 Ethernet
Use this menu to configure internal Ethernet configuration check the printer’s Ethernet module
status, and reset the Ethernet module.
Item
Description
Default
Status
Use this menu to check the Ethernet IP address and
MAC setting status.
N/A
Config.
DHCP:
This item is used to ON or OFF the DHCP (Dynamic
Host Configuration Protocol) network protocol.
Static IP:
Use this menu to set the printer’s IP address, subnet
mask and gateway.
DHCP
Menu Interface Ethernet
Status
Config

TSC MB240 Series Specifications

General

Print Method	Thermal Transfer/Direct Thermal
Resolution	203 dpi
Processor	32-bit RISC CPU
Operating Humidity	25-85% non-condensing
Connectivity	USB 2.0, RS-232
Media Sensor	Reflective, Transmissive
Media Type	Continuous, Die-cut, Black mark, Fan-fold, Notched
Media Width	25.4 mm
Media Thickness	0.06 mm
Media Core Diameter	25.4 mm (1")
Media Max Roll Diameter	127 mm (5")
Ribbon Width	110 mm
Ribbon Length	300 m
Ribbon Core Diameter	25.4 mm (1 inch)
Power	100 - 240 VAC, 50/60 Hz
Maximum Print Length	9999 mm
Label Width	25.4 mm
Label Thickness	0.06 mm
Power Supply	100-240V AC, 50-60Hz
Operating Temperature	5°C - 40°C
Storage Temperature	-20°C - 60°C
Certifications	CE