43
Use this item to setup back feed speed. Setting value is up
to 6 ips.
Use this option to setup printing darkness. The available
setting range is from 0 to 15, and the step is 1. You may
need to adjust your density based on selected media.
The direction setting value is either 1 or 0. Use this item to
setup the printout direction.
This item is used to set the print mode. There are 6 modes
as below,
Next label top of form is aligned to the print
head burn line location. (Tear Off Mode)
Cut the label once at the end of the printing
job.
Enable the label cutter mode.
Enable the label rewinder mode.
Enable the label peel off mode.
Once image is printed completely, label
gap/black mark will be fed to the tear plate
location for tear away.
Same as peeler mode but it doesn’t need
peeler sensor, user could use this mode
with GPIO.
This item is used to fine tune media stop location. Available
setting value range is from -999 dots to 999 dots.
This item is used to fine tune print position. Available setting
value range is from -999 dots to 999 dots.
This item is used to set the origin of printer coordinate system
horizontally and vertically. Available setting range is from 0 dot
to 999 dots.
Use this item to set the code page of international character set.
Use this option to set the country code. Available setting value
range is from 1 to 358.
Note: If printing from enclosed software/driver, the software/driver will send out
the commands, which will overwrite the settings set from the panel.
To Next Page
Loading...
Need help?
General
