3. Setup
3.1 Setting up the Printer
1. Plug the power cord into the AC power cord socket at the rear of the printer.
Then, plug the other side into a properly grounded power outlet.
2. Connect the printer to the computer with the provided USB cable.
3. Push the power switch on “-” side to open the power of printer.
4. If you would like to watch printer installation videos, please scan the QR code
on the right side for more information.
Note: Please switch OFF the printer before plugging in the power cord to printer power jack.
*The interface picture here is for reference only. Please refer to the product specification for the interfaces availability.
To Next Page
Loading...
