TSC Printronix TE200 Series - Loading Label in Peel-Off Mode (Option)

21
3.5 Loading Label in Peel-Off Mode (Option)
1. Open the printer top
cover and refer to
chapter 3.3 to install the
label.
2. Push the print head release
button to open the print
head mechanism and feed
the media through the
media sensor. Move the
media guides to fit the label
width.
3. Lead the media through
the cutter paper
opening.
4. Close the print head
mechanism as indicated.
5. Close the peel-off
module
6. Close the media cover and
and use software to make
calibration then enable the
peel mode. (Please refer to
chapter 4&5)