TSC Printronix TE200 Series - Loading Label in Cutter Mode (Option)

22
3.6 Loading Label in Cutter Mode (Option)
1. Refer to chapter 3.3 to
install the label and use
software to set the
media sensor type and
calibrate the selected
sensor.
2. Open the printer top
cover by pressing the
top cover open tabs
located on each side of
the printer.
3. Push the print head release
button to open the print
head mechanism and feed
the media through the
media sensor. Move the
media guides to fit the label
width.
4. Lead the media through
the cutter paper
opening.
5. Close the print head
mechanism as indicated.
6. Use software or menu
function to enable the
cutter mode.
ress the FEED button
to test.