4. Push the print head release button to open the print
head mechanism.
Note: The black mark sensor position is moveable
and the gap sensor is fixed. Please make sure the
gap or black mark is at the location where media
gap/black mark will pass through for sensing.
5. Feed the paper, printing side face up, through the
media sensor and place the label leading edge
onto the platen roller. Move the media guides to fit
the label width.
6. Close the print head mechanism with both hands
and make sure the latches are engaged securely.
Use hardware of software to set the media sensor
type and calibrate the selected sensor. (Please
refer to chapter 4 & 5.)
To Next Page
Loading...
