Memory full
( FLASH / DRAM )
* The space of FLASH/DRAM is full.
* Delete unused files in the FLASH/DRAM.
* Ribbon and media is loaded incorrectly
* Dust or adhesive accumulation on the print
head.
* Print density is not set properly.
* Printhead element is damaged.
* Ribbon and media are incompatible.
* Reload the supply.
* Clean the print head.
* Clean the platen roller.
* Adjust the print density and print speed.
* Run printer self-test and check the print head test pattern if
there is dot missing in the pattern.
* Change proper ribbon or proper label media.
* The print head mechanism does not latch the print head
properly.
Skip labels when printing
* Label size is not specified properly.
* Sensor sensitivity is not set properly.
* The media sensor is covered with dust.
* Check if label size is setup correctly.
* Calibrate the sensor by Auto Gap or Manual Gap options.
* Clear the GAP/Black mark sensor by blower.
The printing position of small label
is incorrect
* Media sensor sensitivity is not set properly.
* Label size is incorrect.
* The vertical offset setting in the driver is
incorrect.
* Calibrate the sensor sensitivity again.
* Set the correct label size and gap size.
* If using the software BarTender, please set the vertical offset
in the driver.
Missing printing on the left or right
side of label
* Wrong label size setup.
* Set the correct label size.
To Next Page
Loading...
