Why is my TSC TC310 Barcode Reader missing printing on the sides of the label?
If your TSC Barcode Reader is missing printing on the left or right side of the label, the label size setup might be incorrect. Set the correct label size in your printer settings.
How to correct the printing position of small labels on my TSC Barcode Reader?
If the printing position of small labels is incorrect on your TSC Barcode Reader, recalibrate the media sensor sensitivity. Ensure the label size and gap size are correctly set. Fine-tune the Shift Y parameter using DiagTool. If using BarTender software, adjust the vertical offset in the driver settings.
What to do if my TSC Barcode Reader is unable to use the SD card?
If your TSC Barcode Reader is unable to use the SD card, ensure that the SD card is not damaged and use a supported capacity SD card. Also, try reinserting the SD card to ensure it is correctly placed.
Why is the RTC time incorrect when I reboot my TSC TC310 Barcode Reader?
Check if there is a battery on the main board.
General| Model | TC310 Series |
|---|---|
| Type | Barcode Reader |
| Connectivity | USB |
| Supported Barcode Types | Code 39, Code 128, UPC, EAN |
| Operating System Compatibility | Windows, Linux |
| Power Supply | 5V DC |
| Operating Temperature | 0°C to 50°C |
| Humidity | 5% to 95% (non-condensing) |
Illustrates the front view of the TC210 and TC200 series printers with labeled components.
Details the internal components of the printer, showing labeled parts like print head, sensors, and rollers.
Presents the rear view of TC210 and TC200 series printers, highlighting interface ports and power switch.
Lists and describes the connectors on the main board of the TC200/TC300 series printers.
Details the pin configurations for RS-232C, USB, and Centronics interfaces.
Provides step-by-step instructions for replacing the LED or LCD module, including screw removal.
Guides on how to remove and replace the main board of the printer, involving lower cover and connector disconnection.
Instructs on replacing the head open sensor, referencing lower cover removal and screw disconnection.
Details the procedure to remove and replace the platen roller assembly, involving top cover and platen holder tabs.
Explains how to replace the print head assembly, including removing bracket, spring plate, and harness.
Provides steps for replacing the stepping motor, including lower cover removal, connector disconnection, and screw removal.
Details the process of replacing the black-mark sensor module, involving main board removal and screw disconnection.
Guides on replacing the gap sensor (transmitter), involving main board removal and screw disconnection.
Explains how to replace the media holder assembly, involving screw removal and spring assembly.
Provides instructions for installing the optional peel-off module, including platen holder tab manipulation and harness connection.
Details the installation process for the optional cutter module, including harness threading and connection to the main board.
To Next Page
