COPYRIGHT DECLARATION ....................................................................................................... 1
C
OMPLIANCES
......................................................................................................................... 1
1. Introduction ................................................................................................................. 3
2. Getting Started ............................................................................................................ 3
2.1 Unpacking and Inspection ...................................................................................... 3
2.2 Equipment Checklist ............................................................................................... 3
2.3 Printer Parts............................................................................................................ 5
2.3.1 Front View ....................................................................................................... 5
2.3.2 Rear View ........................................................................................................ 5
3 Setup ............................................................................................................................. 6
3.1 Setting Up the Printer ............................................................................................. 6
3.2 Loading Label Stock ............................................................................................... 7
3.3 Peel-Off Installation Assembly (Option) ................................................................. 9
3.4 Loading Label for Peel-off Mode (Option) ............................................................ 12
3.5 External Label Roll Mount Installation (Option) .................................................... 14
3.6 Diagnostic Tool ..................................................................................................... 15
3.6.1 Start the Diagnostic Tool ............................................................................... 15
3.6.2 Printer Function (Calibrate sensor, Ethernet setup, RTC setup)………........ 16
3.7 Setting Ethernet by Diagnostic Utility (Option) ..................................................... 17
3.7.1 Using USB interface to setup Ethernet interface .......................................... 17
3.7.2 Using RS-232 interface to setup Ethernet interface ..................................... 18
3.7.3 Using Ethernet interface to setup Ethernet interface .................................... 19
3.8. Install Memory Card .......................................................................................... 21
4. Power on Utilities ...................................................................................................... 22
4.1 Gap/Black Mark Sensor Calibration ..................................................................... 22
4.2 Gap/Black Mark Calibration, Self-test, Dump Mode............................................. 23
4.3 Printer Initialization ............................................................................................... 27
4.4 Skip AUTO.BAS ................................................................................................... 28
5. Maintenance .............................................................................................................. 29
5.1 Cleaning................................................................................................................ 29
6. Troubleshooting........................................................................................................ 31
To Next Page
Loading...
