TSC XP-DT425B Series - Setup; Setting up the Printer

3 Setup
3.1 Setting Up the Printer
1. Place the printer on a flat, secure surface.
2. Make sure the power switch is off.
3. Connect the printer to the computer with the RS-232 or USB cable.
4. Plug the DC power cord into the power jack at the rear of the printer, and then
plug the AC power cord into a properly grounded receptacle.
Note: When plug power code into the rear of printer please make sure the printer power switch is off.
RS-232C
Power Jack
6
USB
SD Card
Ethernet
Interface
Power Switch