7-2 Model 3775 Condensation Particle Counter
Note: This program will only find CPCs that are on the same
subnet. Example: If the computer is at IP address
10.1.3.1, the device discovery program will find all CPCs
on 10.1.3.x. Also, if the windows firewall in enabled (on
by default in service pack 2) the device discovery will not
find any CPCs. Once the IP address is known, you can
access the Ethernet port on the CPC from another subnet.
3. Select the device and choose Configure network settings.
Figure 7-1
Digi Device Discovery Screen
4. Talk with your network administrator to verify the correct
network settings this device should operate at. If needed, the
MAC address can be located on the back of the instrument or in
this pop-up window. Fill in the appropriate information and
click Save.