3-8 AeroTrak
®
Handheld Airborne Particle Counter
Setup Tab
The Setup tab provides access to the following:
Identify and save the location information associated
with collected samples.
Save a group of settings (a Recipe) that you use
over and over so you do not have to reset
individual settings.
Sets which units are preferred for displaying
environmental measurements taken using optional
measurement probes.
Change Power On Password, Setup Password,
System Configuration, Print Settings, Print Schedule
and Clear Samples
View instrument information such as firmware version,
model, serial number, last calibration date, USB IP
Address, etc.
Set Date and Time, Screen Alignment,
Communications, Regional Settings, and get
device information.