45 mm Heat Shrinkable Tube
Cover connections and the screw pitch with the 45 mm Heat Shrinkable tube, slipped
beforehand on the jumper cable.
Place a ring of adhesive (Hot melt) at the rear of the tube, side cable.
45 mm Heat Shrinkable Tube
Heat the whole with a warm air heater gun to shrink the tube down to the side of the male
connector, all while it maintaining so that it remains well in place. Heat the whole of the
heat-retractable sleeve then.
Heat sufficiently to melt the ring of adhesive until visibility of the adhesive outside the tube
(side cables).
Caution: Do not heat too much, otherwise the jumper cable risks to overheat and melt
Heat to Shrink the Tube down
To Next Page
Loading...
