Zero the weight within tolerance
At G.W mode, get the tare weight. At N.W mode,
clear the tare, get the G.W
Check and read the saved weight data to print.
Switch the weight between the pad weight and the
Press 2 seconds to power on or power off
3.2 Power on & off
Press the "on/off" key for 2 seconds in the shutdown state, and the indicator will start
automatically; Press the "on/off" key for 2 seconds when the indicator is powered on.
When the indicator is powered on, you can check whether there are abnormal strokes or
LCD status indications according to the display, and then enter the weighing state.
3.3 Zero operation
Within the tolerance, “Zero” key clear the weight on all weighing pads. When the
pads unstable or loading over zero range or on tare mode, indicator can’t ZERO and
show ERROR.
3.4 Tare operation
In normal weighing mode, press ”Tare” button to make the load be tare weight; In
accumulative weighing mode, press “Tare” button to preset the tare weight and press
“ print” button to confirm the tare weight. The lights on the keypad is showing. In Tare
mode, press “Tare” button to deduct the tare weight from the total weight and show the
net weight.
NOTE:Tare mode only show on the total weight display.
To Next Page
Loading...
Need help?
General