3.5 Unit Switch
To press “Unit” button for switching the unit between “KG” and “LB”.
3.6 Checking
Weighing mode, press “Check” button to show “C 0030” (30 records existing), input
“C 0020” and press “ Print” to check 20
th
record. Display show “REAd-0”. Choosing”1” to
show date, time, axle, tare weight and total weight one by one. Then “Print 0”, choosing
“1” to print this record and back to the Checking display “C 0020”. Press “Check” Button
again to quit and back to weighing mode.
3.7 Switching
Weighing mode, press “Switch” button to change the display between the axle
weight and the total weight.
3.8 Printing
Manual weighing, press “print” button to print when the pad is stable.
Note:
1.Automatic accumulative weighing mode, press “Print” to print the total weight even if
the number of axle don’t reach the setting number.
2.Press”store”and “print”,to add the current weight data printing.
4. Calibration and Parameter setting
4.1 Enter setting
Press “ Switch” button 3-5 seconds to enter into the menu for setting F1-F5.
The key functions in setting:
ENTER
UP
DOWN
LEFT
To Next Page
Loading...