TUNGSTEN T series ATV winch
9
• Always remove jewelry and
wear eye protection.
• Never lean over battery
while making connections.
• Always verify area is clear of
fuel lines, fuel tank, brake
lines, electrical wires, etc.
when drilling.
• Never route electrical cables:
- Across any sharp edges.
- Through or near moving parts.
- Near parts that become hot.
• Always insulate and protect all exposed wiring and electrical terminals.
• Always install terminal boots as directed in installation instructions.
Step (5) - Checking the System (Figure 9)
Figure 9
Before using the winch, verify the
following:
• Wiring to all components is correct. All loose
wires are tie wrapped tight.
• There are no exposed wiring or terminals.
Cover any existing terminal exposures with
terminal boots, heat shrink tubing or electricians
tape.
• Turn ATV key switch to ON position. Check
winch for proper operation. The wire rope should
spool in and out in the direction indicated on the
switch.
3. Winch Maintenance and Trouble Shooting:
Winch Maintenance
No further internal lubrication is required for the life of the winch . The winch should
not submerge in water (waterproof winch should not be soaked in water for a long
time). If the winch is submerged in water by accident, you should remove the earth
To Next Page
Loading...