1.4 Additional Considerations
Very often clinicians use the following progression during the rehabilitation process: Passive mode,
isometrics, multi-angle isometrics, sub-maximal eccentrics, and concentric isokinetics.
Electrical stimulation may be used in conjunction with any of the tests or exercise modes on the Iso-
Force.
Consider ending a rehabilitation set by work or time, especially if the goal is to improve endurance.
Giving to a subject copies of their rehabilitation reports can help since he/she are more motivated.
Submaximal exercise prevents neural dissociation, promotes articular cartilage nourishment and
proprioception, and retards muscular atrophy.
Delayed Onset Muscle Soreness (DOMS) is not usually apparent until one to two days after treatment.
Work sub maximally to minimize and develop protocols accordingly.
The Iso-Force is a versatile piece of equipment, making it difficult to document every possible setup
position. If a non-documented position is used, please document it by yourself. We would be happy to
make your preferences part of our standard configuration.
1.5 General Considerations before and after Testing
1. Test the dominant or the uninvolved side first
2. Perform stretching exercises, as they have been found to improve muscle performance
3. Ideally 4-5 submaximal and 1 maximal repetitions should be performed as warm-up.
4. Put some ice on the joint involved after exercise or testing
1.6 Safety Considerations
The Laser Pointer placed on the center of the dynamometer axis is used for easy and quick
alignment of the joint to be tested.
Avoid eye exposure to direct or scattered radiation.
To avoid the risk of electric shock, this equipment must only be connected to a supply mains
with protective earth.
To Next Page
Loading...