2.2.5 Bottom Seat For/Aft
Press the bottom of the hand control
With the relative image.
2.2.6 Cervical Support
To reposition the cervical support turn the Cervical Support Knobs (CSK) counter clockwise. Place the
cervical support to the desired position and secure it by turning the CSKs clockwise.
2.2.7 Stabilization Straps
The system comes with the following Velcro straps and belts:
1. Pelvic Stabilization belt. In the middle of the belt, there are two metal hooks. The trunk
stabilization belts are inserted through the hooks. The two edges of the belt are inserted in the
hooks located at the side of the lower seat.
2. Thigh Stabilization straps, permanently placed on the lower seat
3. Trunk Stabilization belts, permanently placed on the back seat
To avoid skin irritation always have a piece of cloth between the Velcro stripe and the patient
tissue.
2.2.8 Hand Grips
The handle grips are covered with foam material for convenience. They can be used by the patient for
added support, stabilization and hands positioning. You can adjust the height of the handgrips by
turning the Hand Grip Knobs (HGK) counter clock wise. After adjusting the position tighten firmly by
turning the HGKs clock wise.
2.2.9 Receiving Tubes
There is one receiving tube placed in the middle of the front part of the seat. For the adapters placed in
this tube please refer to chapter 3. There is a tightening knob permanently placed on the tube. To place
To Next Page
Loading...