Attachments Needed
Dynamometer: AAL02, ADW1
Put the mechanical stops to “B” blue and “B” red.
Collect angle/elbow attachment and the handle grip and combine them as shown in the picture
above
Attach the adapter to the dynamometer by sliding it in the input arm from the top.
Ask the subject to lay on the positioning chair or seat on the chair.
Ask the subject to hold the grip.
Set the axis of the joint rotation. To achieve the alignment make sure the forearm is parallel to the
dynamometer input adaptor. To succeed the alignment you might need to make alterations to the
positions of the chair and the dynamometer.
Check the axis of rotation by asking your subject to perform full elbow flexion
Opposite Side
While the subject still lays on the chair, slide the chair away from the dynamometer and rotate the
former to the other side
Adjust the chair and the dynamometer to align the dynamometer axis with the joint rotation axis
To Next Page
Loading...