A-14 APPENDIX A - REPLACING OVEN COMPONENTS
Replacing Items - Burner Compartment Cover
WARNING: Before removing or replacing any oven component, thoroughly read the safety
instructions found at the front of this manual and Oven Systems (pages 21-28). Adhere to
all precautions and warnings outlined in these sections, as failure to do so could result in
serious injury or death.
CAUTION: Before removing/installing any component, make sure it is disconnected from
the wire harness (where applicable).
HHC-6374 (cooling fan tube) and HHC-6137 (burner compartment cover) removed.
Thermostat, High Limit
Bracket, Thermostat
Wire Harness, LOV, High Limit, 25V
Air Pressure Switch
Wire Harness, LOV, Air Switch, 25V
Burner Assembly
Clamp, Conduit,
1/2 Nominal, Zinc
Combustion Motor (90-degree)
Shutter, Inlet Air Blower
Relay, K4, Sealed, 24 VAC, 20A
Wire Harness, LOV, K4 Ground
Ignition Module
Spark Assembly Wire
Pipe and Valve Assembly
Tube, Flexible, Gas
Shield, Gas Pipe
To Next Page
Loading...
