Need help?Do you have a question about the TurboChef ENCORE and is the answer not in the manual?
General| Model | ENCORE |
|---|---|
| Control Type | Touchscreen |
| Ventilation | Ventless |
| Exterior Finish | Stainless Steel |
| Wattage | 3600 W |
| Category | Oven |
| Cooking Technology | Microwave |
| Power Requirements | 208-240V, 60Hz |
| Cavity Volume | 1.0 cu ft |
| Temperature Range | 500°F |
General safety precautions and warnings for operating the oven.
Precautions to prevent fires, including what to do if ignition occurs.
Proper grounding procedures to prevent electric shock.
Guidelines for replacing a damaged power cord.
Safety checks before and during servicing to avoid microwave energy exposure.
Electrical requirements, including voltage and wattage for different regions.
General instructions for installing the appliance.
Step-by-step guide for physically placing and securing the oven.
Step-by-step cleaning procedures for daily upkeep of the oven.
Description and function of each key on the oven control panel.
Step-by-step guide on how to operate the oven for cooking food.
Viewing recorded fault codes and their timestamps for troubleshooting.
Mode for testing individual oven components, intended for technicians.
Procedure to reset the oven, often used to clear error messages.
Accessing and using Edit Mode to change menu settings and rename items.
Procedure for testing the magnetron's operation and current draw.
Testing the blower motor speed and voltage.
Procedure to test the operation of the top heater.
Procedure to test the operation of the bottom heater.
Performing a test to measure microwave emissions for safety compliance.
Running automated tests to check oven component functionality.
Step-by-step instructions for removing and reinstalling the oven door.
Procedure for aligning and adjusting the oven door for proper closure.
Explanation of the primary, secondary, and monitor interlock switches.
Procedure for adjusting door interlock switches for proper sequence.
Procedure for testing microwave leakage around the door seal.
Information on components within the microwave system.
Information on magnetron operation and power output.
Function and cleaning instructions for the catalytic converter.
How to view fault logs and descriptions of common fault codes.
Description and troubleshooting for blower running status errors.
Description and troubleshooting for low cooking temperature faults.
Description and troubleshooting for low magnetron current faults.
Description and troubleshooting for defective door monitor switches.
Description and troubleshooting for magnetron overheating.
Detailed flowcharts for troubleshooting specific fault codes.
Flowchart for troubleshooting F1 blower errors.
Flowchart for troubleshooting F2 low temperature errors.
Flowchart for troubleshooting F3 magnetron current errors.
Flowchart for troubleshooting F4 door monitor errors.
Flowchart for troubleshooting F5 magnetron temperature errors.
Flowchart for troubleshooting F6 electrical compartment temperature errors.
Flowchart for troubleshooting F7 RTD open errors.
Flowchart for troubleshooting F8 heat low errors.
Troubleshooting for F9 cook cavity temperature high errors.
To Next Page
