42 TROUBLESHOOTING
NO
YES
Replace the
control board.
Correct wiring.
NO
YES
YES
YES
NO
Is the high-limit
thermostat tripped?
Is the blower motor moving air? Check
in Test Mode - see page 19, section
“Blower Motor Test.”
YES
Reset and determine
why it tripped – excess
grease buildup, etc.
The reset button is on
the back panel near the
power cord.
NO
See page 37
to troubleshoot
F1: BLOWER
(Blower Running
Status Bad)
NO
Is the solid state relay
defective or damaged?
Is the top or bottom heater defective? Check
in Test Mode (page 20, section “Top Heater
Test” and “Bottom Heater Test”).
Replace the defective
heater(s).
Verify the solid state
relay is not shorted,
across output, or
open due to the 4-pin
connector not being
properly seated.
Replace the
solid state
relay.
Is the wiring from the solid
state relay to the control
board OK? (See page 48 for
Encore schematic/page 62
for Encore 2 schematic.)
If this fault frequently occurs,
- Ensure the oven is cleaned daily (see pages 5-6).
- Determine if large amounts of grease-laden food are being cooked, and if
so, recommend smaller portions per cook cycle.
Troubleshooting:
F8: HEAT LOW
Troubleshooting:
F9: CC TEMP (Cook Cavity Temperature High)
To Next Page
Loading...
Need help?
General
