TurboChef ENCORE Service Manual

13
INFO MODE
Info Mode
To access the Info Mode, press the “i” key when
the oven is off or cooling down. There are two
Info Mode screens – press the Up or Down key to
switch between them.
Last Temperature Selected
From the Info 1 screen (Figure 5), the last
temperature set point selected to cook is displayed
in the top-left corner of the screen (SP=).
Serial Number
The oven serial number is shown on the Info 1 screen
(Figure 5).
Menu Version
The oven menu version is shown on the Info 1 screen
(Figure 5).
Firmware Version
The oven firmware version is shown on the Info 1
screen (Figure 5).
Cook Counter/Time Logs
From the Info 1 screen (Figure 5), press the key
adjacent to “Counts Scroll”:
- Once to display the cook counter.
- Twice to display total cook time.
- Three times to display total magnetron time.
- Four times to display total “oven on” time.
Voltage - View Incoming
Incoming voltage is shown on the Info 1 screen
(Figure 5).
Fault Log
From the Info 1 screen (Figure 5), select “Fault Log”
to view fault counters for faults F1 through F8. To
view F9 fault detail, press the Down key. To view
time stamps of each fault occurrence, press the soft
key adjacent to the fault code.
Service Numbers
From the Info 1 screen (Figure 5), select “Service
Numbers” to view TurboChef contact information.
Test Mode
From the Info 2 screen, select “Test Mode” (see
page 19) to test oven components. This mode
should only be used by qualified service technicians,
unless otherwise instructed by TurboChef.
Set Options
From the Info 2 screen (Figure 6), select “Set
Options” to access the Options screen (Figure 7).
When prompted, enter the password 9 4 2 8 and
press the Enter key.
Cook More ON/OFF:
Figure 7. The Cook More option controls whether or
not the three “cook more” keys function. This option
must be enabled in order to cook an item beyond its
original cook time (see page 11).
Edit Mode ON/OFF:
Figure 7. The Edit Mode allows the operator to
change cook settings for each item, including item
and group names. See page 17 for more details.
Turning “Edit Mode” off will prevent the operator
from changing menu settings.
Figure 5: Info 1 Screen
Figure 6: Info 2 Screen
Figure 7: Set Options Screen

TurboChef ENCORE Specifications

General

Model	ENCORE
Control Type	Touchscreen
Ventilation	Ventless
Exterior Finish	Stainless Steel
Wattage	3600 W
Category	Oven
Cooking Technology	Microwave
Power Requirements	208-240V, 60Hz
Cavity Volume	1.0 cu ft
Temperature Range	500°F