TurboChef ENCORE - Quarterly Maintenance

7
QUARTERLY MAINTENANCE
1. Complete the daily cleaning
instructions (pages 5-6).
CAUTION: Make sure
the oven is o before
proceeding.
2. Remove the air lter.
3. Clean the cooling fans and
nger guards.
NOTE: A bristle or paint
brush and vacuum are
recommended for collecting
the debris.
4. Clean the louvers on both
side panels.
NOTE: A bristle or paint
brush and vacuum are
recommended for collecting
the debris.
5. Using a Phillips screwdriver,
remove the screws from the
rear vent catalyst housing.
Support the cover with
your hand.
6. e catalytic converter is accordion
style and will pop out when the
cover is removed. Remove the cover
slowly to keep the catalytic converter
in place.
CAUTION: DO NOT attempt
to clean the catalytic converter or
spray chemicals in this area.
7. Clean the housing:
- Hold the catalytic converter in
place with one hand.
- Using a clean towel, wipe out any
debris that has accumulated
beneath the catalytic converter.
- Clean the outer cover and make
sure the vent holes are not blocked.
8. Reattach the outer cover, making sure
the vent holes are at the bottom.
CAUTION: Installing the outer
cover upside down could result in
excessive grease buildup and/or hot
steam present when the oven door
is opened.
10. Reinstall the air lter. e oven is
ready to turn on.
9. Wipe down the back panel with a
clean, damp towel.
Quarterly Maintenance
To ensure optimal oven performance, complete the
following cleaning steps once per quarter or more
frequently as required.
Supplies and Equipment
Required: Phillips screwdriver, clean towels, rubber gloves
for handling catalytic converter
Recommended: dust mask, vacuum, bristle or paint brush