TurboChef ENCORE - Page 20

6 DAILY MAINTENANCE
A
Step 7
Step 8
Step 10
Step 9
Step 11
Step 12
Step 6: Remove Large Food Particles
•eheatingelementcanbeliftedforcleaningunderneath.
DO NOT attempt to clean the heating element.
•Useafoodvacuumordamptoweltoremovelargeparticles from the oven cavity.
Step 7: Clean the Oven Cavity
DO NOT spray TurboChef ® Oven Cleaner into the holes in the oven cavity.
•ApplyOvenCleanertoatowelornylonscrubpadandcleanthetop,sides,and
bottom of the cavity.
DO NOT apply excessive pressure to the waveguide covers (A), located on
each side of the cavity.
•Forstubbornstains,sparinglysprayOvenCleaneronthestain.
•AllowtheOvenCleanertopenetratethestainforveminutes,thenwipeclean.
DO NOT use a hose or water jet for cleaning.
Step 8: Wipe Down the Oven Cavity
•Wipedowntheovencavitywithadamptowel.
•Drytheovencavitywithadrytowel.
Step 9: Clean and Dry the Oven Door
•CleantheovendoorwithOvenCleanerandanylonscrubpad.
•Wipetheovendoorwithadamptowel.
•Drytheovendoorwithadrytowel.
Step 10: Apply TurboChef
®
Oven Guard
•SprayTurboChef®OvenGuardontoadrytowel.
•Wipethecavitywallsandtheinsideoftheovendoor.
DO NOT spray Oven Guard into the oven or apply to the heating element.
Step 11: Reinstall Components
•Reinstallthecavitylter(ifpresent).Besuretoalignthetop-leftpostonthe 
back of the lter with the top-left hole on the back cavity wall. is will ensure the
other posts on the back of the lter t into the wall.
•Reinstallthejetplateandthewirerack.
DO NOT operate the oven without the bottom jetplate installed. Doing so may
damage the oven.
•Closetheovendoor.
•Reinstallthelter,orreplaceitwithanewoneifthemeshisdeteriorated,has 
large openings, or has started to dislodge from the frame.
Step 12: Clean the Oven Exterior
•Wipetheovenexteriorwithadamptowel.
•Removethepanelbeneaththedoor,removeanylargefoodparticlesfromthepanel,
and wipe it with a damp towel.
•Reinstallthepanelbeneaththedoor.
DO NOT spray chemicals into any openings, such as the louvers on the side
panels or the rear vent catalyst housing.
•eovenisreadytoturnon.
Step 6