TURBOCHEF TECHNOLO G I E S, INC.
NGO Rev E Service Manual Changes
© 2009-2010 TurboChef Technologies, Inc.
May 2010
Upper jetplate part number now i1-3204
Added i1-9179 support rails to appendix
Added NGC-1194 switch offset shim (x2)
i1-9029 (SOTA) / i1-9023 (NGO)
SOTA letters: i1-9052 = S, i1-9053 = O,
i1-9054 = T, i1-9055 = A, i1-9056 = Caret
Left ctl: i1-9057 (SOTA) / i1-9453 (SBK)
Right ctl: i1-9058 (SOTA) / i1-9452 (SBK)
Door cover: i1-9109 (SOTA) / i1-9444 (SBK)
Shell: i1-9240 (SOTA) / i1-9445 (SBK)
Medallion: i1-9491 (SOTA) / i1-9489 (SBK)
LED light ring: i1-9198
Front panel: i1-9246 (SOTA) / i1-9458 (SBK)
Keypad: i1-9451-1 (SOTA) / i1-9451-2 (SBK)
i1-3201 = NGO SBK Door Kit
Added LED light ring to “controls” section
Specified “gray” smart card
Various appendix drawing updates
Add to safety instrutions: DO NOT cook with
metal lids or aluminum foil
Add to safety instrutions: DO NOT cook
without food in the cook cavity
Specified i1-3202 waveguide kit
Specified i1-3207 switch paddle kit
Removed blower component (hub, wheel, heat
slinger) part numbers, changed to REF
Appendix housekeeping
Updated door detail and part numbers
Removed blower assembly detail
Specified stirrer blade kit i1-3208
Changed coupling part number from 104134
to 104306
Updated stirrer motor detail
Changed motor controller part number from
100446 to CON-7039
Added international component part numbers
Added i1-3210 shunt plate kit
Added note about how to apply a new keypad
Added note to not apply push nut to trim
prong, to prevent interference with display
Added section: Troubleshooting: Menu settings
are not present
Moved “Write fail” troubleshooting to page 42
Updated schematic
Specified NGC-3033 for primary switch
replacement and modified drawing
Added notes for replacing primary switch
Specified stirrer shaft kit i1-3209
Added verbiage to cleaning instructions about
not forcing the rack out by pulling upward
To Next Page
Need help?
General
